We Got an A.

A tool that looks good on paper and one people actually reach for are two very different things.

There's no shortage of powerful machines. But most are built to hit a spec sheet, not for the welder in the field or the fabricator on the shop floor. The impressive system that's slow to set up and hard to learn ends up collecting dust while people go back to what they know works.

We start with a different question: how does the job get done today, and what would make it easier without a week of training or a manual nobody reads? Answering that question with stellar product design and intuitive controls is what we do.

In 2021, the founders spent their senior year at NC State University on an engineering entrepreneurship capstone project. The prompt was simple: write down all the pain points you've experienced, brainstorm solutions, and choose one that has business and technical merit.

The founders recruited each other, discovered they had highly complementary skillsets, and were equally invested in seeing how far they could stretch a $2,000 budget to develop a prototype of what would eventually become the Mach 1.

Following the final class presentation, Josh, Sam, and Dario met at their go-to taco shop and agreed this wouldn't be the end of CN-Seamless. And yes, we got an A.